Plug and Play - and Enjoy
Here's some great news !
You no longer need to spend a small fortune on complicated electronic devices + Dyno hours, to transform your modern fuel injected bike from being ”OK” to ”Absolutely Marvelous”.
The BoosterPlug is installed in less than 10 minutes. It plugs directly into your bikes wire harness using original connectors – no cutting or splicing.
A true Plug and Play solution that will make your bike so much better
- Improved and softer throttle response when rolling the throttle on-off.
- Enrichment of Fuel/Air mixture when you open the throttle will improve acceleration.
- Remove the Jerky low speed running that is typical for modern lean burn engines.
- No more Puffing in your aftermarket exhaust on engine braking
The IMPORTANT bit !
- The BoosterPlug is a Heavy Duty Quality device.
- All components are sealed and prepared to take the vibration, heat, and moist that they will meet on your bike
- We're not buying expensive motorcycles to have them stranded by flimsy electronics !
The BoosterPlug will trick the Fuel Injection ECU to think the air temperature is lower than the actual readings, and the ECU will richen the injected mixture by a certain amount.
The method have been tested throughly by many independent sources and it actually works. No magic involved :-)
There's several ways to modify the AIT (Air Intake Temperature) signal. I'll explain in details why most of the solutions out there are less than ideal. Read on and make your own choice.
The easy way (not the right way) is to add a resistor in serial with the AIT sensor. Check the Internet forums for your bike – You'll find that a lot of owners have been making experiments.
The bad news is that by tweaking the AIT signal with a serial resistor, the enrichment of the mixture will vary a lot with changes in ambient temperature. You will see almost no enrichment when its cold outside, and a very rich mixture in hot weather.
After a lot of development, calculations and testing I came up with the BoosterPlug. A plug and play device that will deliver the same enrichment within an air temperature range from -20C to +40C.
The IMPORTANT bit !
- The BoosterPlug is the only Plug and Play device that offers a stabilized enrichment of the mixture with different ambient temperatures.
- Read the documentation on the following pages to get the facts .....
For now, the BoosterPlug is only available for BMW and Triumph motorcycles, but I may extend the product range in the future.
Thanks for reading so far, please check the information on the other tabs on this site. I'll try to give you the details and the technical information so you're able to find the right solution for you.
/Jens
|
|
|
Available for:
BMW
G 650 Xcountry
G 650 Xchallenge
G 650 Xmoto
F 650 GS
F 650 Dakar
F 650 CS (Scarver)
F 650 GS (2 cylinder)
F 800 GS
F 800 S
F 800 ST
F 800 R
R 850 R
R 850 RT
R 1100 GS
R 1100 R
R 1100 RT
R 1100 S
R 1150 GS
R 1150 R
R 1150 R Rockster
R 1150 RS
R 1150 RT
R 1200 GS
R 1200 R
R 1200 RT
R 1200 S
R 1200 ST
R 1200 C
HP2 Enduro
HP2 Megamoto
HP2 Sport
K 1200 R
K 1200 S
K 1200 GT
K 1200 LT
K 1200 RS
K 1300 R
K 1300 S
K 1300 GT
Triumph
Tiger 1050
|
