The BoosterPlug is the easiest and most efficient way to upgrade the fuel injection on your DUCATI 1098 .
With the BoosterPlug tuning module you will have a better solution than the complicated and expensive Power Commander that is almost impossible to set up correctly.
No complicated mechanical work or programming is required when installing the BoosterPlug. You simply plug it in using the original connectors and you are done. No problems !
A plug and play tuning solution to improve your motorcycle in so many ways, and the simple way to get rid of the usual idle and stalling problems:
- Eliminate the poor on/off like throttle action
- Stronger acceleration
- Fix the annoying low speed surging
- Stronger idle and less tendency to stall
- Little to no popping in your aftermarket exhaust
This version of the BoosterPlug covers all versions of the DUCATI 1098.
Note: The Ducati 1098 is using the same temperature sensor for the fuel injection calculations as for the temperature readout in the dashboard. (Most other brands have seperate sensors).
This means that your dashboard display will show 20°C / 35°F lower than actual ambient temperature when you install the BoosterPlug, and you may get an ice warning in the dashboard too.
There's no way around this, and it's probably not an issue for most people, but we want you to be informed about it - and it's an easy way to see that the BoosterPlug is working as intended :-)
General Installation Instructions
Bike Specific Installation Instructions