The BoosterPlug is the easiest and most efficient way to upgrade the fuel injection on your Royal Enfield 500 Bullet .
Optimizing the fuel injection on your bike does no longer require expensive and complicated devices like a Power Commander - and no time consuming setup procedures.
You don't have to be a trained engineer or a computer programmer to install the BoosterPlug. Easy and fast plug and play installation.
A true plug and play solution that will make your bike so much better:
- Soft and precise throttle control
- Faster acceleration
- No more low speed surging
- Stronger idle and less tendency to stall
- Deceleration backfires in the exhaust reduced to a minimum
We have seen that Royal Enfield are selling the 500 Bullet with an older generation fuel injection system in some areas outside Europe and USA.
The older fuel injection system have no AIT sensor so you can not use the BoosterPlug on these bikes.
Please download the installation instructions and check if your bike have an AIT sensor on the inner side of the air filter box - before making a purchase.
General Installation Instructions
Bike Specific Installation Instructions