Fuel Injection improvements on the Husqvarna TR650 are usually expensive and complicated. The BoosterPlug is a better and proven alternative.
Did you think the complicated Power Commander was the only way to sort out the fuel injection problems on your bike ? The BoosterPlug will offer the better solutiona at a fraction of the cost.
Installation couldn't be easier - The BoosterPlug comes with the correct connectors to let you plug it in to the bikes wire harnes. No programming required.
There is no better way to solve the common fuel injection problems on the TR650 and improve your riding experience:
- Improved and softer throttle response
- Better acceleration
- Remove the low speed surging
- Stronger idle - no more stalling problems
- Minimize the backfire in your aftermarket exhaust
Note: The Husqvarna TR650 series is using the same temperature sensor for the fuel injection calculations as for the temperature readout in the dashboard. (Most other brands have seperate sensors).
This means that your dashboard display will show 20°C / 35°F lower than actual ambient temperature when you install the BoosterPlug.
There's no way around this, and it's probably not an issue for most people, but we want you to be informed about it.
General Installation Instructions
Bike Specific Installation Instructions
