Improving the fuel injection tuning on your Triumph Speed Triple 1050 is easy and efficient with the proven BoosterPlug solution.
Did you think the complicated Power Commander was the only way to sort out the fuel injection on your bike ? The BoosterPlug will offer the better solutiona at a fraction of the cost.
The BoosterPlug tuning module is installed in less than 10 minutes. It plugs directly into your bikes wire harness using original connectors – no cutting or splicing.
Inexpensive tuning, easy installation, proven results:
- Soft and smooth throttle response
- Harder acceleration.
- The end of the dreaded low speed surging
- Powerfull idle and no more stalling
- Minimize the backfire in your aftermarket exhaust
IMPORTANT: Triumph changed the Air Intake Temperature sensor to a new type in 2010/2011 so you need to check the VIN number (Frame number) to make sure you order the correct BoosterPlug.
This version of the BoosterPlug fits all Speed Triple 1050 from 20005 to 2010 (VIN number from 210445 to 461331).
If you have a newer Triumph Speed Triple 1050, you can find the BoosterPlug tuning module for it in the related products below.
General Installation Instructions
Bike Specific Installation Instructions