Fuel Injection improvements on the Triumph Speed Triple 1050 are usually expensive and complicated and require a lot of additional parts. The BoosterPlug is a better and proven alternative.
Did you think the complicated Power Commander was the only aftermarket solution to sort out the fuel injection on your bike ? The BoosterPlug will offer a better result at a fraction of the cost.
The BoosterPlug requires no programming or advanced mechanical work, and it's easy and fast to install. No extra aftermarket parts required..
Inexpensive, easy installation, proven results:
- Much better and softer throttle response
- Improved acceleration
- The end of the dreaded low speed surging
- Stronger idle - no more stalling problems
- Minimize the backfire in your aftermarket exhaust
IMPORTANT: Triumph changed the Air Intake Temperature sensor to a new type in 2010/2011 so you need to check the VIN number (Frame number) to make sure you order the correct BoosterPlug.
This version of the BoosterPlug fits all Speed Triple 1050 from 2011 to 2015 with VIN number from 461332 and up.
If you have a newer or an older Triumph Speed Triple 1050, you can find the BoosterPlug tuning module for it in the related products below.
General Installation Instructions
Bike Specific Installation Instructions