The BoosterPlug is accepted world wide, as a brilliant and affordable way to modify your Yamaha MT-10 from ”OK” to ”Absolutely Marvelous”.
Did you think the complicated Power Commander was the only way to sort out the fuel injection on your bike ? The BoosterPlug will offer the better tuning solution at a fraction of the cost.
The BoosterPlug is installed in less than 10 minutes. It plugs directly into your bikes wire harness using original connectors – no cutting or splicing.
Inexpensive tuning modification, easy installation, proven results:
- Much better and softer throttle response
- Harder acceleration
- The end of the dreaded low speed surging
- Stronger and more reliable Idle
- Minimize the backfire in your aftermarket exhaust
This version of the BoosterPlug tuning mod covers all versions of the Yamaha MT-10 from 2016 to 2020. The MT-10 is labeled FZ-10 in some countries, but it is the same electronic setup and the BoosterPlug will fit the FZ-10 too.
Please note that we can not build a BoosterPlug for the "2021 and newer" model due to new emission regulations. You can see the detailed explanation here
General Installation Instructions
Bike Specific Installation Instructions